Errors

Error: Not enough storage is available error when embedding documents

Scenario

You may see this error when you embed a supported file into DT FileCabinet.
Error message
Not enough storage is available. Occurred while trying to embed this object as...

Cause

The document that you are attempting to embed is possibly corrupt.

Solutions

Create a new document
  1. Save the document under a different name.
  2. Try to embed the renamed document.
  3. If you're still getting the error, copy the contents of the document into a new document and then save it.
  4. Embed the new document with the copied contents.
Re-embed a new document
Use these steps if you've already embedded the document in DT FileCabinet and it worked previously.
  1. Choose File > Send To > File.
  2. Select the location where you want to save the document (e.g., your workstation's desktop).
  3. Browse to the location where you saved the document and open it.
  4. If you receive any errors, click past them.
  5. Save the file with a different name.
  6. Embed the document with the new name into DT FileCabinet.
Check for invisible content
If you are still getting the error and the embedded document is a Microsoft Office file, it is possible that the file contains invisible content. Sometimes Microsoft Office files that were exported from other applications will have invisible EMF images that Office cannot handle. To remove this invisible content, use the following steps.
  1. Open the file in its native application, outside of DT FileCabinet.
  2. Choose File > Check for Issues > Inspect document.
  3. Mark the
    Invisible Content
     checkbox and then click Inspect.
  4. If the results find invisible content, click Remove All for that category.
  5. Save the file, and embed it into DT FileCabinet again.
  6. Verify that the document opens and closes without displaying an error message.

This article applies to:

  • Product: DT FileCabinet