Navigation

Changing the location in which drawer data is stored

If your organization has set up multiple data locations, you must specify the data location in which you will store your documents. If you do not specify a data location, Digita FileCabinet stores data in a default folder located at C:\WINCSI\FCABDATA, where C is the drive on which you installed Digita FileCabinet.
After multiple data locations have been set up, a Data Location drop-down list appears above the Folders window to allow you to quickly switch between data locations at any time.
You can also choose a data location by following these steps.
  1. Choose Setup > User Preferences.
  2. Select the File Locations tab.
  3. With Digita FileCabinet data highlighted, click the Modify Location button.
  4. Select the desired data location from the
    Data location
     field in the Digita FileCabinet Data Location dialog.
    note
    Data locations must be added in the Data Locations tab of the System Configuration dialog before they will appear in the
    Data location
     field.
  5. Select OK to close the Digita FileCabinet Data Location dialog.
  6. Select OK to close the User Preferences dialog.
note
  • You will also be prompted to choose a data location after adding a data location in the Data Locations tab of the System Configuration dialog.
  • You can also change the data location when adding a drawer, when restoring drawers, or via the Change data location link located on the Digita FileCabinet Home page.

This article applies to:

  • Product: digita-filecabinet