Skip to main content
Data Entry
Search
Search Fixed Assets CS Support Help and Support.

This article applies to:

  • Product: Fixed Assets CS

Configure barcode scanner settings for the Fixed Assets Inventory module

Perform the following steps to configure a barcode scanner for use with the Fixed Assets Inventory module.
note
The Fixed Assets Inventory module is licensed separately from Fixed Assets CS.
  1. In the desktop installation of Fixed Assets CS, open a client.
  2. Open an active inventory.
  3. In the Fixed Assets Inventory module, select
    Setup
    , then
    Barcode Scanner
    .
  4. In the
    Barcode Scanner Settings
     dialog, perform one of the following steps.
    • For RS-232 (serial) barcode scanners, select the
      COM Port
       option and then select the appropriate settings from the
      Port
       and
      Baud
       dropdown lists. Refer to the scanner manufacturer's guide to determine the proper settings.
    • For POS-compliant barcode scanners, select the
      OPOS
       option and then select the name of the scanner from the
      Device Name
       dropdown list. If no devices are listed, verify the scanner software has been installed. It may be necessary to install an updated scanner driver from the manufacturer’s website.
      note
      The
      OPOS
       option is not available in a Virtual Office CS environment.
  5. From the
    Asset label layout name
     dropdown list, select the label you used to print the barcodes.
    note
    The label layout you printed most recently displays in this field by default.
  6. From the
    Barcoded field
     dropdown list, select the field you used to generate barcodes when you printed asset labels. The available selections are based on the selection in the
    Asset label layout name
     field.
    note
    The label layout you printed most recently appears in this field by default.
  7. Select
    OK
     to save the settings.

error-icon

Triva isn't available right now.

Check out the support page for our phone number and hours

error-close