Skip to main content
Set up NetStaff CS
Search
Search Virtual Office CS Support Help and Support.

This article applies to:

  • Product: Virtual Office CS
  • Subject: Setup

Assign applications and modules to NetStaff CS users

Enable modules and applications on a person-by-person basis, or you can give a group of people access to modules or applications. Follow these steps to enable modules and applications on a person-by-person basis.
  1. Select
    Administration
    .
  2. Select
    Users
     in the NetStaff CS section.
  3. Find the staff member in the
    Users
     column.
  4. In the
    Permissions
     section, select
    Enable
     to give the staff member access to that module.
  5. To enable the Virtual Office CS applications, select
    Enable
     next to
    Virtual Office CS
    , mark the checkboxes, and select
    Enter
     to save the changes.
    note
    The checkboxes are grayed for any modules or applications that this person has access to based on their group membership.
  6. To give the current user permission to edit the content of a
    News
     or
    Links
     module, select
    Enable
    . Make sure you mark the
    Edit
     checkbox for any private
    Links
     modules this person will access.
    note
    Edit
     checkboxes are available only if the corresponding module checkboxes have been marked.
  7. When you're done, select
    Enter
    . Any modules you enabled will be available to the current user the next time you signs in to NetStaff CS.

error-icon

Triva isn't available right now.

Check out the support page for our phone number and hours

error-close